Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 209)

Section 6. Network Status and Resolving Communication Problems
devices in its communications link. If Datalogger Network is highlighted, the
status of all devices will be displayed. Note that you can suppress all status
information but potential problems by selecting the Show Potential Problems
Only check box. You can also limit the display to show only dataloggers by
pressing the Display button and choosing Stations Only.
The information will be different for each device, but may include the type of
device, the device name in the network map, the state of communication with
the device, whether or not scheduled data collection is enabled, whether or not
table definitions are valid, modem type, phone number, device address, and the
error rate.
You can click on a potential problem to bring up a menu that allows you to fix
the potential problem or bring up help on the problem.
6.5.1 Status Information
Much of the status information is self-explanatory. Some information which
may require further definition follows.
Communication State – Communication State will be listed as Unknown until
communication is attempted with a device. Once a communication attempt has
been initiated, it will be listed as Normal (communication is successful),
Marginal (there are some errors in communication, but none that cannot be
recovered from), or Critical (communication failed).
6-19