Campbell Scientific LoggerNet Datalogger Support Software User Manual
Page 197
Section 6. Network Status and Resolving Communication Problems
•
Memory Code (Mem Code) – (Array-based dataloggers only) This
number is an indication of the amount of memory available in the
datalogger. The amount of memory represented depends on the
datalogger. See the datalogger operator’s manual for more information.
•
Next Data Collection (Next Data Coll) – The date and time of the next
scheduled data collection for the device.
•
Polling Active – True indicates that LoggerNet is currently receiving data
for this device.
•
Program Overrun (Prog Overrun) – (Array-based dataloggers only)
This is the number of table overruns recorded for the running datalogger
program. This is the same number available from *B mode with keyboard
displays or through the terminal mode.
•
RFTD Blacklisted – Indicates that a station has been blacklisted by the
RF Base following a failed communication attempt. The RF Base will not
forward communication attempts originating from LoggerNet to a
blacklisted station. This includes clock checks, getting table definitions,
data collection, program sends, etc. However, the RF Base will continue to
request communications with the blacklisted station on its regular RF
Polling Interval. Once the station has responded to one of these regular RF
polling broadcasts, it will be removed from the blacklist. At that point,
communication attempts originating from LoggerNet will be allowed
again.
•
Table Defs State – Indicates the status of the datalogger’s table
definitions, as known by the LoggerNet server.
None – No table definitions have been retrieved from the datalogger.
Current – The table definitions from the datalogger match what LoggerNet
has stored as the table definitions for the datalogger.
Suspect – A collection attempt has returned an invalid table definitions
code. LoggerNet will attempt to verify the table definitions for the
datalogger.
Getting Table Defs – LoggerNet is in the process of retrieving the table
definitions from the datalogger.
Invalid Table Defs – The table definitions from the datalogger do not
match what LoggerNet has stored as the table definitions for the
datalogger. Table definitions will need to be updated before data
collection can occur.
•
Total Attempts – The total number of communication attempts with the
device since LoggerNet was started or retries were reset.
•
Total Failures – The total number of communication attempts with the
device that have failed since LoggerNet was started or retries were reset.
6-7