Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 224)

Section 7. Creating and Editing Datalogger Programs
This setting is similar to the Integration setting in that the dialog box will be
displayed only the first time you create a program for a specific datalogger
type, and the setting will apply to all programs created or edited for that
datalogger, unless it is changed via the Program menu. Note that programs
containing sensor files that are filtered from the list of Available Sensors will
still load and work correctly in Short Cut.
The Integration and the Sensor Support settings are persistent
settings for each datalogger model. The first time you create a
program for a particular datalogger model, you will be presented
with these two dialog boxes. The state of these settings is saved
between Short Cut sessions. Any subsequent new or edited
programs that are generated after a setting has been changed will
reflect the change as well.
Each time you create the first program for a datalogger model you
will be presented with these dialog boxes (e.g., the first time you
create a CR10X program, you must initialize these settings; the
first time you create a CR1000 program, you must initialize these
settings).
The settings can be changed at any time and the datalogger
program will be regenerated to use the new setting when you click
the Finish button on the Home screen.
After making your selections, note that the title bar shows the datalogger type
and scan interval.
Once you have saved the file, the filename will replace “untitled.scw”.
NOTE
7-6