F.5.3 – Campbell Scientific LoggerNet Datalogger Support Software User Manual
Page 566
Advertising
Appendix F. Calibration and Zeroing
F.5.3 Using the Wizard to Perform Zeroing Calibrations
In the Wizard, select
Zero for the type of calibration.
Select the sensor you wish to calibrate, press
Next.
If the variable is configured as an array of sensors, you may select an
individual item to calibrate only that element, or you can select the entire array.
Now you can monitor the reading on the sensor to be calibrated. Set the sensor
to the zero condition, and press
Calibrate.
F-12
Advertising