Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 231)

Section 7. Creating and Editing Datalogger Programs
Short Cut can also create programs for dataloggers using a variety of interface
devices, including multiplexers and special interfaces for sensors. Add these
devices by selecting them from the Devices folder in the Available Sensors and
Devices tree.
Once you’ve added a device, such as the AM16/32 multiplexer, a tab is added
to the screen for that device, and the sensors available for that device are
shown:
You can then add sensors to that device just as you would to the main
datalogger.
Note that, once you add a sensor to a multiplexer, it may limit what kind of
sensors can be added thereafter, as each sensor on the multiplexer must share
the same wiring between the multiplexer and the datalogger.
After adding all the desired sensors, click Next.
7-13