Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 465)

Section 14. Troubleshooting Guide
TABLE 14-1. Socket Error Messages
Socket
Error
Number Message Meaning User Response to Message
10013 Permission Denied.
The requested socket
connection has refused
the connection.
This is normally a network type of
issue. Check with your computer
network operator.
10024 Too many open files.
Too many open sockets
for the applications
running.
This can occur when you have many
applications that are using sockets
running at the same time.
10047 Address family not
supported by protocol
family. The socket
being addressed does
not support the type of
connection being
attempted.
This message shows up when the
LoggerNet Toolbar comes up but
the server did not come up because
TCP/IP is not installed on the
computer. Install TCP/IP and restart
LoggerNet. (Section 1.2,
Configuration of TC/IP Service)
10055 No buffer space
available. Cannot
create more temporary
sockets.
The operating system cannot create
any more socket connection. See
the text above about Maximum
Number of Sockets Open.
10058 Cannot send after
socket shutdown. A
message was sent to a
socket that has been
closed.
This would be an indication that an
application is not communicating
well with the server. Check the
application.
10060 Connection timed out. Either the server has crashed and is
not responding or the application
did not maintain the connection to
the server. Try restarting
LoggerNet. This message can also
be seen in connection with the
NL100 LAN interface.
10061 Connection refused.
The LoggerNet server
or an NL100 refused to
allow the socket
connection.
This is normally associated with the
NL100 and occurs because the last
connection did not have enough
time to close before a new
connection is requested. Slow down
the low level polling delay interval.
10065 No route to host. The
application is trying to
connect to a host
address that isn’t in the
routing table.
This occurs with remote connections
to a LoggerNet server running on
another computer. The requested
host name can’t be found.
14-3