Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 226)

Section 7. Creating and Editing Datalogger Programs
Note that this sensor not only offers a custom name field and units, but also
allows you to correct for sea level, a common practice in measuring
atmospheric pressure. In the middle of the screen, look over the notes (or refer
to the Help for this sensor), for this sensor may require other sensors or have
limitations. When you choose OK, Short Cut adds the necessary instructions
with appropriate multipliers and offsets.
In some cases, multiple sensors of the same type can be added at one time.
These sensors will have a How many sensors? parameter as the first parameter
on the form as shown below. The maximum number of sensors that can be
added will be indicated. The maximum will vary, depending upon the sensor
and the number of other sensors already configured in the program. If the
sensor form includes calibration and/or conversion parameters (e.g., multiplier,
offset, gage factor), there will be a Set button next to these parameters.
Pressing this button will allow you to set unique values for each sensor.
Measurement name
Measurement units
Notes specific to
this sensor
7-8