RADWAG WLC 0,6/A1/C/2 Precision Balance - Manual (Page 33)

- 33 -
15.2. “Beep” signal – after pressing a key
Procedure:
 Enter the submenu <P5.othr> and then:
bEEP no - switched off
bEEP YES - switched on
Return to weighing:
See 11.2.2.
15.3. Automatic switch-off
This function is essential to save the battery power. The scale is switched
off automatically when (function t1 = YES) no weighing appears in 5
minutes. (no changes on the display). In case when this function disrupts
the operation (e.g. long time weighing procedures) or while working with
connection to mains, switch off this function.
Operation according to the power supply:
Setting
Operation
Mains Batteries / accumulator
t1 = 0 disabled disabled
t1 = YES enabled enabled
t1 = Auto * disabled enabled