RADWAG WLC 0,6/A1/C/2 Precision Balance - Manual (Page 73)

- 73 -
The frame format sent by the indicator in case of setting <P2.Prnt>
to Cntb:
1 2 3 4 5 6 7-15 16 17 18 19 20 21
S U I stability space sign mass space unit CR LF
20.7. Configuring printouts
General information
If some information included are redundant or not sufficient and there
is a necessity of changes one can design their own protocol format in
EDYTOR WAG computer program. This piece of software is accessible
in: http://www.radwag.com
21. ERROR COMMANDS
Err2 - Value beyond the zero range
Err3 - Value beyond the tare range
Err4 - Calibration mass or start mass beyond the acceptable
range (  1% for weight,  10 for start mass)
Err5 - Mass of a single piece lower than the scale division
Err8 - Exceeded the time for tarring, zeroing, start mass
adjustment or span adjustment
NULL - Zero value from the AD converter
FULL2 - Measurement range overflow
LH - Start mass error, the mass on the weighing platform is
beyond the acceptable range (-5% to +15% of start mass)
5-FULL - Display range overflow in totalizing
Notice:
1. Errors: Err2, Err3, Err4, Err5, Err8, null, that appear on the display
are also signalled by a short beep sound (about 1 sec.);