RADWAG WLC 0,6/A1/C/2 Precision Balance - Manual (Page 60)

- 60 -
17.2. External calibration
Option only for non-verified scales
Not accessible in WLC…/C/2 scales of WLC series
Procedure:
 Enter submenu <P6.CAL> and then:
 Following messages will be displayed:
 During this time start mass is adjusted, and after completing the
procedure calibration weight mass is displayed (e.g. 3.000kg),
 Place the required weight on the pan,
 Calibration process starts automatically after placing the
adequate weight that is signalled by the following message: