RADWAG WLC 0,6/A1/C/2 Precision Balance User Manual
Page 40
- 40 -
If option
<LASt> is choosen in the scale program displays estimated
unit mass of the last piece (about 3 sekonds) and then goes to
Counting pieces automatically setting the previously displayed
value as valid for the procedure.
If the
<FrEE> option is selected you will see:
Using
and
enter the required sample quantity,
where:
- selection of digit position,
- setting the digit,
Confirm the value by pressing
,
You will see
<LoAd> on the display and then:
If weighing is performed in a container put the container on the pan
first and then tare it. Then put the declared quantity of pieces on the
pan and confirm it when stable (signalled by
):
The program will automatically calculate the mass of a single piece
and go on to the
Piece Counting mode (pcs). You will see the
following display:
- WLC 6/A2/C/2 Precision Balance WLC 1/A2/C/2 Precision Balance WLC 120/C2/K Precision Balance WLC 120/C2/R Precision Balance WLC 60/C2/K Precision Balance WLC 60/C2/R Precision Balance WLC 30/F1/R Precision Balance WLC 20/A2 Precision Balance WLC 12/F1/R Precision Balance WLC 10/A2 Precision Balance WLC 6/F1/K Precision Balance WLC 6/F1/R Precision Balance WLC 6/A2 Precision Balance WLC 2/A2 Precision Balance WLC 1/A2 Precision Balance WLC 0,6/A1 Precision Balance WLC 0,6/B1 Precision Balance