Konica Minolta Printgroove - Manual (Page 102)

Printgroove POD Queue Tools 5
Printgroove POD Queue 5-31
Punch Punch Edge:
Left/Right/Top/
Bottom
Punch Hole: 2/3/
4 A job may require finishing on two different edg-
es. For instance, Spiral Bind Left and 2-Hole
Punch Bottom are valid settings for a single job
ticket. However, Konica Minolta devices do not
support multiple inline finishing options. When
POD Queue processes a job with such settings,
the Binding setting will always take priority. If a
Punch Edge and Punch Holes are listed here, it
means that the Punch location differs from the
job’s Binding location. The Punch settings must
be completed offline.
The setting is noted on the Banner Page of the
job.
Punch Edge:
Bottom
Punch Hole: 2/3/
4 Punch Edge: Bottom is not supported by Koni-
ca Minolta devices. If the value appears here,
the punch option must be completed offline.
The setting is noted on the Banner Page of the
job.
Layout Orientation Printgroove POD Queue prints a true represen-
tation of the PDF file. The Orientation cannot be
modified from the source file’s original layout. If
the PDF file is Portrait it cannot be changed to
Landscape and vice-versa. If a value appears
here that is different from the PDF file, it cannot
be applied. Resolve using one of the following
options:
• If a change in Orientation is required, add a
Note explaining the situation in the Notes
field, return the job to POD Guide and use a
Makeready application to change the Layout.
• Process the job without applying the setting.
The setting is noted on the Banner Page of the
job.
Size Policy 1:
Reduce to Fit, Fit
to Page, Clip to
Max, Tile Printgroove POD Queue prints a true represen-
tation of the attached PDF file. If Reduce to Fit,
Fit to Page, Clip to Max or Tile are selected on
the Job Ticket, POD Queue cannot apply these
settings. Resolve using one of the following op-
tions:
• Add a note explaining the situation in the
Notes field, return the job to POD Guide and
use a Makeready application to change the
Layout.
• Process the job without applying these set-
tings.
The setting is noted on the Banner Page of the
job.
Non-Supported Settings Processing Options
Setting Sub-Setting Processing Options