Konica Minolta Printgroove - Manual (Page 105)

Printgroove POD Queue Tools 5
Printgroove POD Queue 5-34
When a print job is created in Printgroove POD Serve or Guide, and the Print
Type selected is Duplex (Double-Sided in Queue), conflicting Binding Posi-
tion settings for Staple and Punch may exist. Since Duplex settings must be
completed in-line, these settings will remain unchanged. Printgroove POD
Queue will automatically move conflicting Staple and Punch Binding Position
settings to the Non-Supported Settings panel. You may review these set-
tings and complete the binding off-line.
All Non-Supported Settings appear on each print job’s Banner page. This is
done to provide a hard-copy reference for these settings, something espe-
cially useful when the Non-Supported option must be completed offline. If
the Banner Page setting is Off, the Banner page will not print. For complete
information about Banner Page settings, please see “Banner Page Options”
on page 3-19.
Per Page Settings Paper Size These values are not recognized by Printgroove
POD Queue. These values and the pages to
which they apply are noted. Resolve as follows:
Load the correct paper into a tray, then select
the same tray via the Job Ticket Editor (Inter
Sheet Settings --> select the setting to which
this Paper Size applies, click Edit, then select
the correct tray from the Paper Source drop-
down).
Drag-and-drop the job to the device to which
the selected tray belongs and the job should
print on the correct paper.
These settings ARE NOT noted on the Banner
Page of the job.
Binding Position
Paper Type
Paper Weight
Paper Color
Use Perforate
Paper
Tab Type
Perfect Binding Cover Paper
Type The values for the Perfect Binding Cover are
noted here.
These settings ARE NOT noted on the Banner
Page of the job.
Cover Paper
Weight
Cover Paper
Color
Target Device Profile [Printgroove
POD Ready op-
erator defined
value] The operator has selected a target device profile
selected by the POD Ready operator. Note this
value and resolve as required.
These settings ARE NOT noted on the Banner
Page of the job.
Prepress Imposition N-Up These are the imposition settings applied by the
Printgroove POD Ready operator and are noted
here as referenced.
These settings ARE NOT noted on the Banner
Page of the job.
Step & Repeat
Print Position Left, Middle,
Right The Print Position value is noted here.
These settings ARE NOT noted on the Banner
Page of the job.
Non-Supported Settings Processing Options
Setting Sub-Setting Processing Options