Konica Minolta Printgroove - Manual (Page 50)

Configuring Printgroove POD Queue 3
Printgroove POD Queue 3-29
3.7.8 Enabling Printer Options
In order for Printgroove POD Queue to properly implement Auto Mode or Se-
lection panel recommends, it must understand which finishing options are in-
stalled for each printer. After Enabling a printer, double-click the printer's
icon to open the Printer Monitor. By default, the Options page is displayed.
From here you must install all available finishing options for all discovered
and manually added printers. Please see “Options” on page 5-72 for details
about this procedure.
3.7.9 Exporting Printgroove POD Queue Printer Capabilities
If another Printgroove POD module allows the user to select a printer before
the job is sent to Printgroove POD Queue, that module must import a Print-
groove POD Queue printer capabilities file. The JDF file that is generated
contains current setup and configuration information for all Discovered print-
ers. To create and export a Printer Capabilities file, follow this procedure:
1
Select [File] --> [Export] --> [Printer Capabilities].
2
The Save As screen opens. Specify the storage location.
3
Click the [Save] button. A JDF file is created and stored in the specified
location.
This file must then be imported into another Printgroove POD module in or-
der to read and store the values. That procedure is discussed in the User’s
Guide for the specific module.