Konica Minolta Printgroove - Manual (Page 39)

Configuring Printgroove POD Queue 3
Printgroove POD Queue 3-18
3.6.3 Completed Jobs Options
The number of jobs stored in the Completed Jobs panel can be specified
from the Completed Jobs Options screen.
These settings may be set or modified at any time after the Server Setup is
complete and user accounts are created. Anyone with an Operator or higher
user-level can modify this setting.
1
From the menu select [Configuration] --> [Operation Setup] --> [Com-
pleted Jobs Options]. The Completed Jobs Options screen opens.
2
By default, the Maximum Number of Stored Jobs value is set to 200.
You may enter a new numeric value in the field (the range is 1 - 200).
3
Click the [Save] button to apply the settings.
2
Note
The Printgroove POD server must be restarted for these changes to take
effect.
3.6.4 Auto Mode Settings
When Auto Mode is On, Printgroove POD Queue reads the job ticket settings
of incoming print jobs and compares these to the printer capabilities of all
Enabled printers (as well as the Clusters that contain these printers). If an ex-
act match is found, the job is automatically routed to a matching Cluster or
a printer's queue and processed normally.
Check the Status Bar for the current Auto Mode setting. [Auto Mode: On] dis-
plays when Auto Mode is active. If Auto Mode is not active, [Auto Mode: Off]
is displayed in the Status Bar. [Off] is the default setting.
Auto Mode may be activated or deactivated at any time after the Server Set-
up is complete and user accounts are created. Anyone with an Operator or
higher user-level can modify this setting.
1
From the menu select [Configuration] --> [Operation Setup] --> [Auto
Mode]. The Auto Mode screen opens.
2
Select the [Auto Mode On] or [Auto Mode Off] radio button.
3
Click the [Save] button to apply the settings.