JLG G6-42P Service Manual - Manual (Page 32)

Section 2 - Pre-Operation and Inspection
2-6 31200148
2.3 WALK-AROUND INSPECTION
Begin your walk-around inspection at item 1, as noted below. Continue to your right
(counterclockwise when viewed from top) checking each item in sequence.
INSPECTION NOTE: On all components, make sure there are no loose or missing
parts, that they are securely fastened and no visible leaks or excessive wear exists
in addition to any other criteria mentioned. Inspect all structural members including
attachment for cracks, excessive corrosion and other damage.
1. Boom Sections & Lift, Tilt, Extend/Retract, Compensating (Slave) Cylinders -
• Check front, top, side & rear slider pads for adequate grease.
• Pivot pins secure; hydraulic hoses undamaged, not leaking.
• Check extend/retract cables and adjustment blocks for adequate tension.
2. Front Axle - Pivot pins secure; hydraulic hoses undamaged, not leaking.
3. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
OY0181
3
1
4
5
6
7
8
9
10
11
12
13
14
15 2
16