JLG G6-42P Service Manual - Manual (Page 324)

32
Section 4
Assembly and Installation
5. If ring gear is mounted on opposite brake housing
side, loosen two capscrews that fasten pinion
bearing cage. Remove cage and mount it after
differential case is assembled.
If ring gear is mounted on brake housing side,
install other capscrews that fasten pinion bearing
cage. Tighten the capscrews to a torque of
67-91 lb-ft (91-120 N•m).
Install Differential Housing
Assembly into Main Housing
(With Shims)
1. The preload of differential bearings is adjusted by
selecting proper shim pack to obtain a torque of
15-35 lb-in (1.7-4.0 N•m).
2. Install shims. Combine two shims to obtain
desired thickness. Figure 4.28.
NOTE
Usually a 0.102-0.104 inch (2.60-2.65 mm) shim
pack thickness is enough to obtain specified
backlash and differential bearing preload.
3. Install differential case bearing cup, axle shaft
housing and brake housing studs into main
housing until the thread is completely attached.
Apply Three Bond 1134 liquid gasket material on
stud threads. Figure 4.28.
4. Install differential case assembly. Figure 4.29.
5. Install brake housing and other differential case
bearing cup. Figure 4.30.
6. Install three bolts to adjust differential on brake
housing. Tighten to a torque of 19-26 lb-ft
(26-36 N•m). Figure 4.31.
Figure 4.28
Figure 4.29
Figure 4.30
Figure 4.31
NUT
COUNTER NUT
T
T
T