JLG G6-42P Service Manual - Manual (Page 84)

Section 5 - Attachments
5-22 31200148
To Swing:
• Pull Swing Switch (4) back, located on dash panel to activate Swing function.
With Swing Switch activated, move the auxiliary control joystick (3) down to
swing forks right or up to swing forks left.
To Raise/Lower Mast:
• Pull Forks Raise/Lower Switch (5) back, located on dash panel to activate Forks
Raise/Lower function. With Forks Raise/Lower Switch activated, move the
auxiliary control joystick (3) down to raise forks or up to lower forks.
To Side Shift:
• Press Side Shift Switch (6) forward, located on dash panel to activate Side Shift
function. With Side Shift Switch activated, move the auxiliary control joystick (3)
down to shift forks right or up to shift forks left.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-7.
Operation:
• Always lower forks fully in mast and position forks straight ahead before
engaging load.
• To drive with a load, lower forks fully in mast, keep forks pointed forward and
travel in accordance with the requirements set forth in Section 1 - General Safety
Practices.
• Use a signal person to assist in positioning load if necessary.
WARNING
CRUSH HAZARD. Always level forks (horizontally) and telehandler frame before
swinging load to side. Swinging unlevel forks could cause load to slide off forks.
WARNING
CRUSH HAZARD. Do not use mast to push or pull objects or load. Failure to
comply could cause object or load to fall.