JLG G6-42P Service Manual - Manual (Page 104)

Section 7 - Lubrication and Maintenance
7-12 31200148
Engine Oil
A. Engine Oil Level Check
1. Perform “Shut-Down Procedure” on page 4-4.
2. Remove dipstick (1) and check oil mark. The oil should be between the full (2)
and add (3) marks within the crosshatched area of the dipstick. Replace
dipstick.
3. If oil is low, open the engine cover, remove oil fill cap (4) and add motor oil to
bring oil up to the full mark in the crosshatch area.
4. Replace oil fill cap.
5. Close and secure the engine cover.
Note: The standard service interval for engine oil and filter is 250 hours maximum.
If an extended service interval is desired, see the engine manual for specific
guidlines for optimizing oil change intervals.
10
OX0140
3
2
ADD
1
4