JLG 24RS Service Manual - Manual (Page 19)

SECTION 1 - SPECIFICATIONS
3121287 – JLG Lift – 1-7
1.1 OPERATOR MAINTENANCE
NOTE: The following numbers correspond to those in Figure 1-1.,
Maintenance and Lubrication Diagram.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NOR-
MAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/
OR EXPOSED TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION
FREQUENCIES MUST BE INCREASED ACCORDINGLY.
1. Swing Bearing
Lube Point(s) - 2 Fittings
Capacity - A/R
Lube - BG
Interval - Every 3 months or 150 hrs of operation
Comments - Apply grease and rotate in 90 degree
intervals until bearing is completely lubricated
2. Swing Gearbox
Lube Point(s) - Fill Plug
Capacity - 32 ounces (946 cc)
Lube - EPGL
Interval - Check level every 150 hrs/Change every 1200
hours of operation. Fill to cover ring gear.
3. Hydraulic Tank
Lube Point(s) - Fill Cap
Capacity - 36 Gal. (136.3 L), 32.5 Gal. (123 L) to Full Level;
26.5 Gal (100.3 L) to Refill Mark
Lube - HO
Interval - Check Level daily; Change every 2 years or
1200 hours of operation.
Comments - On new machines, those recently over-
hauled, or after changing hydraulic oil, operate all sys-
tems a minimum of two complete cycles and recheck
oil level in reservoir.
Table 1-10. Lubrication Specifications.
KEY SPECIFICATIONS
BG* Bearing Grease (JLG Part No. 3020029) Mobilith SHC 460.
HO Hydraulic Oil. API service classification GL-4, e.g. Mobilfluid 424.
EPGL Extreme Pressure Gear Lube (oil) meeting API Service Classification GL-5
or Mil-Spec Mil-L-2105.
MPG Multipurpose Grease having a minimum dripping point of 350° F (177°
C). Excellent water resistance and adhesive qualities, and being of
extreme pressure type.
(Timken OK 40 pounds minimum.)
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104. Diesel - API
CC/CD class, MIL-L-2104B/MIL-L-2104C.
*MPG may be substituted for these lubricants, if necessary, but service intervals will be
reduced.
DRAIN
FILL