JLG 24RS Service Manual - Manual (Page 56)

SECTION 3 - CHASSIS & TURNTABLE
3-18 – JLG Lift – 3121287
HOUSING-SHAFT DISASSEMBLY
1. Set the unit on a work bench so the housing (1G) flange
is down.
SAFETY GLASSES MUST BE WORN DURING THESE NEXT STEPS.
2. Remove the retaining ring (1K) from the output shaft
(1A).
3. Bend the tang on the lock tanged-washer (1I) out of the
locknut (1J).
4. Remove and discard the locknut (1J). A new locknut
must be used for reassembly.
5. Remove the lock tanged-washer (1I) from the output
shaft (1A).
6. Remove the thrust washer (1H) from the output shaft
(1A).
7. While supporting the housing (1G) on the output shaft
(1A) end, press the output shaft (1A) out of the housing
(1G).
NOTE: The lip seal (1B) will be pressed out of the housing (1G) by
the bearing cone (1D) during this step.
8. Remove the Bearing Cone (1F) from the Housing (1G).
9. Use a bearing puller to remove the bearing cone (1D)
from the shaft (1A).
10. Bearing cups (1C & 1E) will remain in the housing (1G).
NOTE: If bearing replacement is necessary, the bearing cups (1C &
1E) can be removed with a slide hammer puller or driven
out with a punch.
1A Output Shaft
1B Lip Seal
1C Tapered Bearing Cup
1D Tapered Bearing Cone
1E Tapered Bearing Cup
1F Tapered Bearing Cone 1G Housing
1H Tanged Washer
1I Lock Tanged-washer
1J Bearing Nut
1K Retaining Ring
Figure 3-12. Housing Shaft Disassembly