JLG 24RS Service Manual - Manual (Page 85)

SECTION 3 - CHASSIS & TURNTABLE
3121287 – JLG Lift – 3-47
Installation
1. Install lifting eyes into the swing bearing for installation.
NOTE: The swing bearing weighs approximately 132 lbs. (60 kg).
2. Attach an adequate lifting device to the swing bearing
and place it onto the mounting holes on the frame.
Refer to Figure 3-36., Swing Bearing Installation for
proper bearing alignment.
3. Apply JLG Threadlocker Part No. 0100019 to new outer
race swing bearing bolts. Install the bolts and torque to
280 Nm (206.5 lbs.ft.) in the pattern shown in Figure 3-
37., Swing Bearing Torque Sequence.
4. Install guide pins into two of the inner race mounting
holes to help line up the turntable when it is installed.
5. Attach chains to the lifting lugs on the turntable.
6. Slowly lower the turntable and align it with the guide
pins.
7. Apply JLG Threadlocker Part No. 0100019 to new inner
race swing bearing bolts. Install the bolts and torque to
280 Nm (206.5 lbs.ft.) in the pattern shown in Figure 3-
37., Swing Bearing Torque Sequence.
8. Route the hydraulic hoses on the right side of the
machine into the hole on the turntable and connect
them to the drive valve as tagged during removal.
9. Route the drive hoses from the drive valve up to the
drive pump.