JLG 4017PS Service Manual - Manual (Page 192)

Electrical System
9-34 3706PS, 3707PS, 4014PS, 4017PS, 33.7, 37.6, 37.7
b. Disassembly
DO NOT disassemble the pump. The pump is not
serviceable. Replace pump if found to be defective.
c. Installation and Testing
1. Install the reservoir into the mounting bracket.
Secure with the previously used hardware.
2. Connect the windshield washer hoses to the
reservoir.
3. Connect the cab wiring harness connectors to the
reservoir connectors.
4. Fill the washer fluid reservoir with washer fluid.
5. Install the fuel tank. Refer to Section 7.6.2, “Fuel
Tank.”
6. Install the hydraulic oil reservoir. Refer to Section
8.7.3, “Hydraulic Oil Reservoir Removal/Installation.”
7. Properly connect the battery.
8. Turn the ignition key switch to the RUN position and
press the washer switch. Verify that fluid is sprayed
on the windshield, roof and rear glass.
9. Close and secure the engine cover.
10. Remove the Do Not Operate Tag from the ignition
key switch and the steering wheel.
9.12 SOLENOIDS, SENSORS AND
SENDERS
9.12.1 Transmission Solenoid Valves
Note: If the transmission is not shifting properly, the
transmission shift control switch (travel select lever),
wiring harness or transmission shift solenoids (6) should
be checked in order to determine which component is
defective. Specific information to determine which travel
position and corresponding component is not responding
can be found in the detailed transmission service
instructions (covering repair, disassembly, reassembly
and adjustment information) are provided in the following
publications:
Detailed transmission parts and service information can
be found in SIS Web.
The transmission should be checked, serviced and
repaired only by experienced service technicians who are
aware of all safety instructions and particular component
features.
Note: Contact the local JLG dealer if internal
transmission repair is required during the warranty
period.
MZ6490
6
6
6
6
7