Det-Tronics EagleVision - PC - Manual (Page 13)

To further identify a device on the loop, place the cursor on the square,
but do not click. The description/identifier that was entered for this
device at the time of configuration will be displayed below the square.
For complete status information for this node, double click on the square
to open the point display screen for the device. (Refer to Section VII or
VIII for information regarding Point Display screens.)
E
VENT
L
OG
(F
OR
E
AGLE
V
ISION
-NT
WITHOUT
W
ONDERWARE
)
A complete listing of all system status events is displayed on a window
that runs the full width of the screen at its bottom. (The event log window
can be moved to any position on the screen by clicking on the title bar
and dragging it to the desired location.) To open the Event Log, click on
Event Log under the View menu. See Figure III-2.
The event log displays system events as they occur. Each new event that
occurs will appear at the bottom of the window and any previous events
will move up. Information displayed includes LON number, device
address and type, date and time, description of event, and event status
(on or off).
IMPORTANT
The event log window must be open for this feature to function.
Events that occur prior to opening the event window will not be
displayed.
If screen space is at a premium, click on Minimize under the Window
menu. The events log window is reduced to a button labeled “Events”
in the lower left hand corner of the screen. All events occurring while
the event log is “minimized” will be recorded. To view the events log,
double click on the button.
Clicking on Maximize under the View menu causes the event log to fill
the entire screen.
3.4
C
ONFIGURATION AND
S
YSTEM
M
ONITORING
O
VERVIEW
FIGURE III-2
Event Log Window