Det-Tronics EagleVision - PC User Manual

Page 83

Advertising
background image

Unable to Configure. This bit is set by the gateway when it was
unable to successfully transfer configuration information to the SAM.

Inhibit Active. This bit turns on to indicate that the gateway relays
and display are inhibited from responding to changes in the status of
the SAM. The inhibit active status bit is controlled by the “Inhibit” but-
ton.

Not Communicating. This bit is set by the gateway when its diag-
nostic routine indicates that it has not received periodic status messages
from the SAM. The bit is cleared when a new status update is received.

Invalid Configuration. This bit indicates that configuration informa-
tion is invalid and is set on a new unit, when the address is changed,
or when invalid data is transferred. A valid configuration must be down-
loaded to clear the bit.

Output 1 and 2 Active. These indicators turn on while the output cir-
cuit is active.

Output 1 and 2 Shorted. These indicators turn on while the output
circuit is shorted.

Output 1 and 2 Open. The open indicators turn on when the output
circuit is not properly terminated. A wire could be open or the device
being monitored could be defective.

Low Aux Voltage. This indicator turns on when the auxiliary input
voltage is below the specified limit. This fault is self-clearing when the
correct auxiliary power input voltage is applied.

Auto Config Fault. This bit is set when the gateway was unable to
successfully download configuration information.

U

PDATE

R

ATE

This field shows in milliseconds how often the SAM will report its status
to the gateway. The update rate is programmable from 1 to 10 seconds
on the SAM configuration screen.

A

LARM

A

DDRESS

This area shows the address of the logic controller that is configured for
communication with this SAM. All trouble status data will be sent to the
address listed here. The address can be changed on the SAM configu-
ration screen. It is important to ensure that the logic controller is config-
ured to communicate with this device.

7.26

E

AGLE

Q

UANTUM

P

OINT

D

ISPLAYS

Advertising