Det-Tronics EagleVision - PC - Manual (Page 31)

7. Click on the Defaults button to set the Update Rate and Release Time
(if selected) default values. If a different Update Rate or Release Time
value is desired, enter the value in the appropriate box.
8. Enter the Destination Address. (Refer to step 7 under “DCU
Configuration” for instructions regarding selection of destination
addresses.)
9. Click on Accept. Click on Close to exit and return to the Point
Configuration screen, or use the scroll arrows to select the next point
for configuration.
S
IGNAL
A
UDIBLE
M
ODULE
(SAM) C
ONFIGURATION
1. Highlight the desired address on the Point Configuration screen.
Click on the Modify Point button.
2. Click on the Define button.
3. Click on the SAM button, then click on OK. The SAM Configuration
screen will be displayed. See Figure V–11.
4. Type a tag name for the point in the space provided.
5. Assign a trigger for the point.
6. If latching output is desired, check the Latch Enable box.
95-8479
5.15
E
AGLE
Q
UANTUM
S
YSTEM
C
ONFIGURATION
FIGURE V-11
SAM Configuration Screen