Det-Tronics EagleVision - PC - Manual (Page 56)

2. Click on the Define button.
3. Click on the Relay Node button, then click on OK. The Relay Node
Configuration screen will be displayed. See Figure VI–3.
4. Type a tag name for the point in the space provided.
5. Assign a trigger for the point.
6. Select the operating mode.
Start/End mode: Relay node responds to addresses in the speci-
fied range. Only the starting and ending address-
es are specified. All detectors within the range of
contiguous points will be monitored.
List mode: Only messages from device addresses specified
on the list will be processed.
7. Enter the addresses to be monitored in the appropriate “Source
Addresses” boxes.
NOTE
Clicking on the Defaults button will clear all entered source
addresses.
6.6
E
AGLE
2000 S
YSTEM
C
ONFIGURATION
FIGURE VI-3
Relay Node
Configuration Screen