Det-Tronics EagleVision - PC - Manual (Page 26)

4. Type a tag name for the point in the space provided.
5. Assign a trigger for the point.
6. Define engineering units and enter the name in the box provided.
7. Enter the full scale value in the “High” box under Engineering
Range. The Low value must be 0.
8. Under Calibration Type, select either manual or automatic for the
type of calibration that will be used. (Refer to the hardware manual
for complete calibration information.)
9. Click on the Defaults button to display the default values for cali-
bration gas, high and low alarm setpoint, and update rate. If other
values are desired, enter them in the appropriate boxes. (Refer to
“When a K Factor is Used” above if a K factor is being used for sen-
sor calibration.)
10.Enter the Destination Address(s). (Refer to step 7 above for instruc-
tions regarding selection of destination addresses.)
11.Click on Accept. Click on Close to exit and return to the Point
Configuration screen, or use the scroll arrows to select the next point
for configuration.
IDC C
ONFIGURATION
1. Highlight the desired address on the Point Configuration screen.
Click on the Modify Point button.
2. Click on the Define button.
3. Click on the IDC button, then click on OK. The IDC Configuration
screen will be displayed. See Figure V–7.
5.10
E
AGLE
Q
UANTUM
S
YSTEM
C
ONFIGURATION