3 source output cable and connection, Figure 2-13 – INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual User Manual
Page 35
2 - 13
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
Figure 2-13 5.5 MHz test crystal
2.1.2.3 Source Output Cable and Connection
NOTE: Source output connections are not required if the IQM-233 card is used
only as a monitor. In this case, the IQM-233 card installation is complete
and the following procedure is not required.
1
Construct a source output cable for one, two, or three source output channels.
NOTE: The source output cable is user provided.
A 15-pin male high-density D-sub connector is provided with the IQM-233
card, to be used for the source output cable connection to the IQM-233
card. See
for the source output pin assignments.
The connector type used for the other end of the cable depends upon the
requirements of the source power supply or other equipment.
5.5 MHz Test Crystal
Table 2-2 Source output pin assignments
High-Density D-sub
Function
Pin 1
Output 1
Pin 2
Output 2
Pin 3
Output 3
Pin 4
Not Used
Pin 5
Not Used
Pin 6
Ground
Pin 7
Ground