4 source output configuration and verification – INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual User Manual
Page 37
2 - 15
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
3
Connect the other end of the cable to the source power supply or other
equipment.
CAUTION
Care must be taken in connecting the IQM-233 card
source outputs to the source power supply or other
equipment. Failure to follow the equipment
manufacturer’s instructions can result in damage to the
equipment and/or the IQM-233 card.
2.1.2.4 Source Output Configuration and Verification
NOTE: The following steps are not required if the IQM-233 card is used only as a
monitor.
1
In the IQM-233 Standard window, click Setup >> General. See
Figure 2-16 Setup list
2
The Setup window is displayed. See
3
Select the Control Enabled check box.
4
Click OK to display the IQM-233 Standard window with Sensor Information
and Source Information panes. See
.