INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual - Manual (Page 23)

2 - 1
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
Chapter 2
Installation and Interfaces
2.1 Installation
Figure 2-1 shows a typical IQM-233 card system installation.
Refer to the sensor’s operating manual for sensor installation instructions.
To install the IQM-233 card, Dynamic Link Library (DLL), device driver, and
IQM-233 Standard software, read the installation requirements in
section 2.1.1 ,
and then perform the installation procedure, starting at section 2.1.2 on page 2-5 .
Figure 2-1 Typical system installation
Computer with
Oscillator
6 in.
SMA/BNC
Long BNC cable
User provided
Source
Substrate
Crystal
Earth
Source Power Supply
IQM-233 card installed
source output cable
BNC cable
Cable
Sensor
Ground