INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual User Manual
Page 72
4 - 6
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
SqmSystemState (long *CardTypeInstalled, long
*ActiveCardType, long *NumCardsInstalled, long
*NumOutputsTotal, long *NumSensorsTotal, long
*NumOutputsPerCard, long *NumSensorsPerCard, long *Sim,
long *NumActiveCards)
Sets the material-specific parameters for each of the sensors.
CardTypeInstalled. . . . . . . . . . . Type of card physically installed
0 = No card
1 = SQM-242
2 = IQM-233
ActiveCardType . . . . . . . . . . . . Type of card currently being run or emulated
1 = SQM-242
2 = IQM-233
NumCardsInstalled. . . . . . . . . . Number of actual cards installed
NumOutputsTotal . . . . . . . . . . . Total outputs for all cards, either physical or
emulated
NumSensorsTotal . . . . . . . . . . . Total sensors for all cards, either physical or
emulated
NumOutputsPerCard . . . . . . . . Number of outputs per card
NumSensorsPerCard . . . . . . . . Number of sensors per card
Sim. . . . . . . . . . . . . . . . . . . . . . . Current simulation mode
0 = Not in simulation mode
1 = SQM-242
2 = IQM-233
NumActiveCards . . . . . . . . . . . Number of cards currently running, either
real or emulated