INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual - Manual (Page 39)

2 - 17
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
5 On the menu bar, click Setup >> Source.
6 The Source Setup window displays. See Figure 2-19 .
Figure 2-19 Source Setup window
7 For each source output connected to a source power supply, enter a value in
the Full Scale (V) box(es) equal to the maximum input voltage allowed for the
source power supply. Click OK to save the configuration. For detailed
information, see
section 3.3.3.1.4, Source, on page 3-14 .
8 In the Sensor Information pane of the IQM-233 Standard window, select a
connected Output from the Map Sensor list (see
Figure 2-20 ). For detailed
information, see section 3.3.3.2, Map Sensor, on page 3-15 .
Figure 2-20 Map Sensor list
9 In the Source Information pane, select Manual from the Source Control list
(refer to
Figure 2-18 ). For detailed information, see section 3.3.4.4, Source
Control Operating Functions, on page 3-23 .
Figure 2-21 Source Control list