INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Operating Manual - Manual (Page 41)

3 - 1
PN
07
4-
58
4-
P1
A
IQM-233 Operating Manual
Chapter 3
IQM-233 Standard Software
3.1 Introduction
IQM-233 Standard software is used to monitor or control a simple process using a
single IQM-233 card or SQM-242 card.
Features include:
 Single layer or codeposition control of up to three materials.
 Output parameters for controlling source power supplies.
 Saving of setup parameters and deposition data.
 Simulation of deposition for developing and testing a deposition process.
3.2 How To Install IQM-233 Standard Software
3.2.1 DLL Installation
The Dynamic Link Library (DLL), device driver for the IQM-233 or SQM-242 card,
and WinDriver are installed by the IQM233 DLL or the SQM242 with IQM DLL
setup file. To install the DLL, device driver, and WinDriver:
NOTE: IQM233 DLL and SQM242 with IQM DLL cannot be installed together on
the same computer.
NOTE: If IQM-233 and SQM-242 cards are installed together in the same
computer, IQM-233 Standard software will detect only one IQM-233 card
and ignore the SQM-242 card(s). The IQM-233 card(s) must be removed
to use IQM-233 Standard software with an SQM-242 card.
1 If the operating system is Windows 7 or 8, click Start >> Control Panel >>
System. Note the operating system size (32-bit or 64-bit) displayed under
System type.
If the operating system is Windows XP, click Start >> Settings >> Control
Panel >> System >> System Properties >> General tab. Determine the
operating system size from the operating system name displayed under
System:
 Windows XP Home, Windows XP Media Center Edition, and Windows XP
Professional are 32-bit.
 Windows XP Professional x64 Edition is 64-bit.
2 Insert the Thin Film Manuals CD into the computer’s CD drive.