Leica Biosystems ST5020 - Manual (Page 42)

42 Instructions for Use, V1.9, RevD - 12/2012
5.4.3 Password allocation
Fig. 37
→ →
Attention!
• A distinction is made between capital and
small letters.
If the entry made is correct, the new pass-
word will have to entered twice. Each time,
press ENTER.
When switching between user and supervisor mode, switch the password
verification on or off:
• Press PASSWORD VERIFICATION.
• The alphanumeric keyboard opens up - enter the password.
• If the password is correct, the password verification button will be
switched from ‘yes’ to ‘no’ and vice versa.
→
Switching password verification on/off
Changing the supervisor password
• To change the password, the currently valid password must be en-
tered first.
• Press ENTER, (keyboard opens up) and enter the current password.
• If an erroneous entry is made, an error message will be displayed
which must be acknowledged.
Any changes in this menu require supervisor access level.
You may switch to supervisor mode only while no racks are being processed.
After the new password
has been entered twice, a
confirmation message will
be displayed.
• Fig. 37 shows all three command prompts
displayed when changing the password.
5. Operation