Leica Biosystems ST5020 - Manual (Page 56)

56 Instructions for Use, V1.9, RevD - 12/2012
Station details
• Press one of the station buttons to access
the STATION DETAILS menu.
• If a station is empty, only the CHANGE STA-
TION TYPE button (8) is displayed.
• If CHANGE STATION TYPE is pressed, the
menu STATION TYPE CHOICE (
Fig. 53 ) opens
up where you can see which station types
can be allocated to a particular station. But-
tons corresponding to station types which
cannot be selected are disabled.
• Pressing one of the enabled buttons
changes the station type without any further
confirmation being required and leads you
back to STATION DETAILS.
• Depending on the station type chosen, addi-
tional station information is displayed.
Information displayed for all station types (9):
- station number,
- station type,
- rack number.
Rack number only if a rack is in the station.
If there is no rack in the station, the symbol
(-) is displayed.
Additional information can be found in the
row below and on the right side of the
screen (10).
• Additional buttons allow the user to select
further settings, depending on the type of
station.
5.5.3 Select station type
Fig. 52
Fig. 53
Caution!
The Leica ST5020 is not capable of verifying the actual content of a station. Therefore the
user MUST make sure that the information entered into the STATION DETAILS menu is
consistent with the reagent the station has actually been filled with.
8
↓
9
10
↑ ↓
5. Operation