Lenze ESV SMV frequency inverter - Manual (Page 46)

44 Lenze SMVector 13465100 EDBSV01 EN v18
Commissioning
4.5.7 Diagnostic Parameters
Code
Display Range (READ ONLY) IMPORTANT
No. Name
p500 Fault History • Displays the last 8 faults
• Format: n.xxx where: n = 1..8,
1 is the newest fault; xxx = fault message (w/o the F.)
• Refer to section 5.3
P501 Software Version Format: x.yz
P502 Drive ID A flashing display indicates that the Drive ID stored in the EPM
does not match the drive model it is plugged into.
P503 Internal Code Alternating Display: xxx-; -yy
P505 DC Bus Voltage 0 {VDC} 1500
P506 Motor Voltage 0 {VAC} 1000
P507 Load 0 {%} 255 Motor load as % of drive’s output current rating.
Refer to section 2.3.
P508 Motor Current 0.0 {A} 1000 Actual motor current
P509 Torque 0 {%} 500 Torque as % of motor rated torque (vector mode only)
P510 Output Power kW 0.00 {kW} 650.0
P511 Total kWh 0.0 {kWh} 9999999 Alternating display: xxx-; yyyy when value exceeds 9999
P512 Heatsink Temp 0 {°C} 150 Heatsink temperature
P520 0-10 VDC Input 0.0 {VDC} 10.0 Actual value of signal at TB-5 (See P162)
P521 4-20 mA Input 0.0 {mA} 20.0 Actual value of signal at TB-25 (See P162)
P522 TB-5 Feedback P204 P205 TB-5 signal value scaled to PID feedback units (See P162)
P523 TB-25 Feedback P204 P205 TB-25 signal value scaled to PID feedback units (See P162)
P524 Network Feedback P204 P205 Network signal value scaled to PID feedback units
P525 Analog Output 0 {VDC} 10.0 Refer to P150…P155
P527 Actual Output
Frequency 0 {Hz} 500.0
P528 Network Speed
Command 0 {Hz} 500.0 Command speed if (Auto: Network) is selected as the speed
source
P530 Terminal and
Protection Status Indicates terminal status using segments of the LED display.
(Refer to section 4.5.7.1)
P531 Keypad Status Indicates keypad button status using segments of the LED
display. (Refer to section 4.5.7.2)
P540 Total Run Time 0 {h} 9999999 Alternating display: xxx-; yyyy when value exceeds 9999
P541 Total Power On Time 0 {h} 9999999
P550 Fault History 1 8 • Displays the last 8 faults
• Format: n.xxx where: n = 1..8,
1 is the newest fault; xxx = fault message (w/o the F.)
• Refer to section 5.3
P551 Fault History Time 0 {h} 999999 Display: “n.hh-” “hhhh” “mm.ss” = fault #, hours, seconds
The “hhhh” screen is displayed after hours exceed 999.
P552 Fault History Counter 0 255 Number of sequential occurrences of a fault.
For example: 3 external faults occur over a period of time
with no other errors occurring. Then P552 will indicate 3,
P550 will indicate the error EF and P551 will indicate the
time of the first fault occurrence.