Lenze E84Dxxxx - Manual (Page 126)

14 Implemented CIP™ objects
14.2 EtherNet/IP objects
126
Lenze · Decentralised frequency inverter 8400 protec (EtherNet/IP™ option) · Communication Manual · DMS 3.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Instance attribute "Status" (attribute 1)
Instance attribute "Configuration Capability" (attribute 2)
Bits Name Description
0 ... 3 Interface Configuration
Status
• 0000: No TCP/IP configuration available (attribute 5)
• 0001: Valid TCP/IP configuration (attribute 5) via BOOTP, DHCP or
static/permanent storage
• 0010 ... 1111: Reserved
4 Mcast Pending This bit indicates a pending change of the multicast configuration in
attribute 9 (Mcast Config) and/or the TTL value ( C13019 ). It is set to ’1’ if
either a multicast attribute or the TTL value is set.
The pending change will only take effect after a reset of the device
("power off/on" or "type 0 reset"). This bit is then reset to ’0’.
5 Interface Configuration
Pending
This bit indicates a pending change of the TCP/IP configuration in
attribute 5 (Interface Configuration). It is set to ’1’ if an attribute is set.
The pending change will only take effect after a reset of the device
("power off/on" or "type 0 reset").
6 AcdStatus Display of the status of address conflict detection (ACD, C13847 ):
• 0: No address conflict detected
• 1: Address conflict detected
7 ... 31 - Reserved (0)
Bits Name Description
0 BOOTP Client The state ’1’ indicates that BOOTP is used for the TCP/IP configuration of
the device.
1 DNS Client Is not supported (state ’0’).
2 DHCP Client The state ’1’ indicates that DHCP is used for the TCP/IP configuration of
the device.
3 DHCP-DNS Update Is not supported (state ’0’).
4 Configuration Settable The state ’1’ indicates that the TCP/IP configuration can be set in
attribute 5 (Interface Configuration).
5 Hardware Configurable Is not supported (state ’0’).
6 Interface Configuration
Change Requires Reset
The state ’1’ indicates that changes of the TCP/IP configuration in
attribute 5 (Interface Configuration) will only take effect after a reset of
the device ("power off/on" or "type 0 reset").
The state ’0’ is not supported (changes becoming effective immediately).
7 AcdCapable The state ’1’ indicates that the device is provided with address conflict
detection (ACD).
8 ... 31 - Reserved (0)