Lenze E84Dxxxx - Manual (Page 57)

Lenze · Decentralised frequency inverter 8400 protec (EtherNet/IP™ option) · Communication Manual · DMS 3.0 EN · 07/2014 · TD17
57
8 I/O data transfer (implicit messages)
8.5 I/O configuration with »RSLogix 5000« version 19 or lower
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7. Under I/O Configuration in the configuration tree, right click "1769-L32E Ethernet Port
LocalENB" and select "Properties".
8. Go to the Connection tab and set further properties.
Required setting
Optional settings
9. Complete the settings with OK.
• The I/O configuration is now complete.
• The corresponding tags will then be created in the "Controller Tags" of the controller
project.
10. The last step is Saving the I/O configuration in »RSLogix 5000« ( 68) .
Setting Description
Requested Packet
Interval (RPI)
Set RPI  4.0 ms. (Standard setting: 10 ms)
The RPI [ms] specifies the intervals for the I/O data exchange between the inverter
(adapter) and the controller (scanner).
Settings Description
Inhibit module This option serves to interrupt or inhibit the communication to the adapter.
Major Fault On
Controller If Connection
Fails While In Run Mode
This option serves to put the drive into the error status if the EtherNet/IP connection
to the inverter fails while the controller is running.
Use Unicast Connection
over EtherNet/IP
Option deactivated (standard setting):
• The input data is sent from the adapter to the scanner by means of multicast
telegrams.
• Other scanners can access this data in addition to the currently configured
scanner ("Listen only" or "Input only" connections).
Option activated:
The input data is sent from the adapter to the scanner by means of unicast
telegrams.