6commissioning – Lenze E84Dxxxx User Manual

Page 30

Advertising
background image

6

Commissioning

6.3

Setting the IP configuration of the Inverter Drive 8400 protec

30

Lenze · Decentralised frequency inverter 8400 protec (EtherNet/IP™ option) · Communication Manual · DMS 3.0 EN · 07/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2. A double-click on a EtherNet/IP node opens the "Configure nodes" dialog window.

Here you can set the IP parameters.

3. Click on Transferred.

• The IP configuration is transferred to the corresponding EtherNet/IP node.
• The Inverter Drive 8400 protec carries out a stack reset.
• The IP parameters are written to codes

C13000

(IP address),

C13001

(subnet mask), and

C13002

(gateway address).

• Code

C13005

(IP configuration reference) is set to ’0: Saved address’ to ensure that the

transferred address can be used.

Tip!
Check whether the configuration has been transferred successfully.
For this purpose, open the Assign IP addresses dialog window (see step 1) and click on the

Find device button.

Advertising