Lenze 8615E - Manual (Page 103)

8.2 Language
CO98 you select the language of the display texts.
The Standard setting is German.
Code Name Parameter (Factory setting is in Acceptance
CO98 L a n g u a g e German SH + PRG
E n g l i s h
8.3 Display of value
CO50 to CO54 you read different values.
Act. value
Output frequency
Act. value of PI controller
M o t o r v o l t a g e
bus voltage
Motor
Display
absolute in Hz
with Cl72 = related to
with Cl72 -1-: absolute in Hz
absolute in
absolute
in V
a b s o l u t e i n
8.4 Switch-on display
If connect the controller to the mains, the output frequency is
shown as the first display If you want to set another
information as switch-on display, enter the corresponding
number
CO04.
Code Name
CO04 Switch-on
display
Parameter (Factory setting is prlnted in bold)
xxx Code number for display after mains
c o n n e c t i o n
Acceptance
SH + PRG
8.5
On the display of the keypad you see Software is
loaded in the controller. For this, select
you work with LECOM, you see the controller type
3
101