7 act. value, 8 act. value 0 – Lenze 8615E User Manual
Page 95
The
of “pulse inhibit” is indicated by the illuminated
LED on the keypad and the permanently assigned digital output
terminal 45. Pulse inhibit means that the output of the frequency
controller is inhibited. Possible
are:
l
Controller inhibit
l
Fault
TRIP
l
(see page 99)
If you need the permanently assigned output terminal 45 with
polarity you must use a freely assignable output and set
the polarity as required.
5.4.7 Act. value
In
with Pl controller, the assigned output indicates
that the set
of the drive has been reached. If you want the
output to
even before
the setpoint, enter a range
where you want the
to be active.The
thresholds are the
is reduced and increased by the
entered value.
Code
Name
Parameter (Factoty setting is printed in bold)
Acceptance
Window
0.5 %
0 . 0 %
(0.1
100.0 % ON-LINE
v a l u e =
In
control the
“setpoint reached” is transferred to
the ‘output “act. value =
5.4.8 Act. value 0
In
with Pl controller, the assigned output indicates that
the drive has
to standstill (see page 80).
3
3
3