Lenze 8615E User Manual
Page 120
9.12
Tandem
9.13.1 Digital frequency output
The digital frequency output is required e.g. for a
coupling (two motors are connected by
to one
shaft).
For
couplings it is
that, in
of
of the
e.g. due to the
limiting function
the
the same field frequency to the motor as the
A frequency
which is proportional to the field frequency
be supplied to terminal
To activate this function the value 200
must be set
CO08. The corresponding setting of
be calibrated
CO30 (see
5.6).
Information
the
drive
The
drive
either be equipped with the series Software or
the variant Software. Only the
drive must be equipped with
the variant Software
which is valid for the dancer-Position
control and thus the control of the field frequency.
Caution!
The acceleration and deceleration times (CO1
of the
must be 0 sec in the tandem
Otherwise, the
shaft will undergo
when accelerating or decelerating the
drive.
118