Lenze 8615E - Manual (Page 108)

9.5 Adjustment of analog inputs
l
Offset adjustment of the analog input terminals (setpoint
input 1) and terminals (setpoint input 2):
Adjustment only with activated controller inhibit
via low at terminal 28).
With the final an
unwanted Operation of the drive may occur
adjustment and activated controller enable. That
means, the drive could accelerate to while
adjusting the inputs when the setting controller enable
is activated, although only a very
was
provided.
For more information the procedure see 3.6
l
Gain adjustment of the analog input, terminals 3, 4
dancer-Position value):
The gain of the input voltage is adapted via a switch
combination of the DIO switch
is located at the left-hand side of the control board
8602MP (board with control terminals). For this, remove the
of the controller.
U s e Remarks
2 -1 ov ov
= + sign
Actual value dancer -1 OV OV S e t t i n g f o r S t a n d a r d
1 + sign Sensors
Actual value dancer -30V
+ sign
Actual value dancer -60V
+ sign
Actual value dancer -90V
+ sign
Actual value dancer -120V setting
+ sign
internal ground (GND)
Master voltage or -lov
1 2 b i t + s i g n
( d e p e n d i n g o n s w i t c h
106