Lenze 8615E User Manual
Page 18
2.5.2 EC
of Conformity ‘95
for the purpose of the EC
relating to
Compatibility
amended by:
First amended directive
CE mark directive
The controllers of the 8600 series
be driven in stand-alone
Operation for the purpose of the regulation
compatibility (EMVG of
and 1st
amended
directive of
The EMC
only be
when
integrating the
into a drive System.
Lenze GmbH Co KG, Postfach 10 13 52, D-31763 Hameln
declares that the described “CE-typical drive
with the
controllers of the type
und
comply with the above
mentioned EC directive.
The compliance with the protective requirements of the above
mentioned EC directive was confirmed by the award of the
EMC
of the accredited test laboratory: VDE Prüf- und
Zet-tifizierungsinstitut, Offenbach
The conformity evaluation is based on the working
of the
product Standard for drive Systems:
EMC product
including specific
methods for power drive Systems
Considered generic Standards:
Generic
Standard
EN
Generic Standard for the emission of noise
Part 1: Residential areas, commercial premises, and
businesses
EN
Generic Standard for the emission of noise
(used in addition to
2: Industrial premises
requirements of IEC
The emission of noise in
premises is
limited in
2 2 G )
I E C 2 2 G .
50082-2
G e n e r i c S t a n d a r d f o r n o i s e i m m u n i t y
Part 2: Industrial premises
The requirements of noise immunity for residential areas were
considered
these are less
Considered
Standards for the test of noise emission:
Housing and mains
15 1000 MHz
i n i n d u s t r i a l
S t a n d a r d
u s e d i n a d d i t i o n
t h e
for use in residential and commercial
industrial premises
16