Lenze 8615E - Manual (Page 86)

5.2.4 frequencies
you need fixed settings as main setpoint, you
programmed setpoints via the JOG frequencies. These JOG
frequencies replace Please note that in configurations
with additional setpoints, the 2 is set to zero, as long as a
JOG frequency is
Programming of JOG frequencies
The JOG frequencies are set in two
l
Select a JOG frequency CO38
l
CO39, enter a value you want to assign to the
selected JOG frequency
you require several JOG frequencies, repeat the first two
correspondingly. The JOG frequencies must be entered as
absolute values. A maximum of 15 JOG frequencies
be
programmed.
Code Name Parameter (Factory setting is printed in bold) Acceptance
C O 3 8 P r e s e l e c t i o n : JOG 1 SH + PRG
JOG JOG 2
frequency . . . .
JOG 15
C O 3 9 f o r -480 Hz -100 Hz ON-LINE
C O 3 8 -100 Hz (0.1 Hz} Hz
Hz 480 Hz)
Assignment of the digital inputs
The number of required inputs for the function “Enable JOG
frequency” depends on the amount of the required JOG
frequencies.
Number of required JOG
frequencies
Number of requlred inputs
at least
a t least 2
a t least 3
4
A maximum of four inputs be assigned to this function. For the
assignment of the inputs see the on page 81.
84