Lenze 8615E - Manual (Page 93)

Name Parameter (Facto- is printed in bold)
Preselection: Digital output Al SH + PRG
freely D i g i t a l o u t p u t A 2
assignable D i g i t a l o u t p u t A 3
d i g i t a l o u t p u t D i g i t a l o u t p u t A 4
Relay output Kl
for N o f u n c t i o n SH + PRG
Output frequency smaller than
Maximum reached
Ready
P u l s e i n h i b i t
Fault
reached
Act. value =
-1 A c t . v a l u e = 0
P o l a r i t y f o r Output HIGH active SH + PRG
Cl17 Output LOW active
function be assigned to one output, including the
relay output. you want to re-assign an output, the previous
is lost.
A which is already assigned to an output, only be
assigned to another terminal or the relay output, if the previously
used output has been assigned to another function.
of the freely assignable digital
5.4.1 Frequency below a certain threshold,
The indicates via the assigned output that the output
frequency is smaller than the threshold set C017. For example,
you c:an use the output for a holding brake and CO17
at which output frequency the brake is to be released or engaged.
Code Name Parameter (Factory setting is printed in bold) Acceptance
C O 1 7 Threshold for 2 Hz 7.5 Hz (0.1 Hz} 100 Hz ON-LINE
function 480 Hz)
91