Lenze 8615E - Manual (Page 44)

Moulded module resistors on heatsink
d
b
Brake resistor Dimensions
Resistance Order number a
b
d e k
mm m m mm mm mm mm mm
3 7 0 240 7 0 2 2 5 9 5 5 7.5
2 4 0 340 7 0 3 2 5 7 0 5 7.5
Brake resistor
Resistance Order number
3 7 0
2 4 0
P o w e r
kW
0 . 1 5
0.2
Resistor values
Peak brake power
kW
1.4
2.2
Heat capacitance
3 0
3 0
6.2 Mains
Advantages of using a mains
l
Less mains disturbance
The wave shape of the mains current sinusoidal; at
the same time the current is reduced by up to 40%
of the mains load, the load and the fuse load).
l
Increased life of the Controller
A mains the AC load of the DC bus capacitors
and thus doubles its Service life.
l
The transient high-energy overvoltages are sometimes
generated at the mains side by circuit breakers or fuses are
stopped by the mains
and thus the units are usually not
damaged.
l
Low-frequent radio interference be reduced.
Please note:
l
When a mains is used, the maximum possible output
voltage does not the value of the mains voltage.
typicat voltage drop at the rated 4 to 5%.
l
Mains are always required when the Controller is
operated with increased or maximum power.
42