1 example of how to select a configuration – Lenze 8615E User Manual
Page 65
Advertising
3.2.1
Example of how to select a configuration
The
of rotation of the motor in a
is to be
determined by the sign of the analog
for CW
rotating field,
for CCW rotating field).
A closed-loop
control is to be used, for
a DC
serves as act. value. A
2 is not used.
The corresponding configuration
be determined as follows:
The table “Closed-loop
control” contains two configurations
where the
1 is provided analog as bipolar setpoint. These
are the Parameters -1 and
The desired closed-loop
control using DC tachogenerator is possible with Parameter
-1
The
2 via terminals and 2 is
but is not
required. Therefore its influence must be set to zero as
from
couplings. Please observe the
on page 68.
63
Advertising
This manual is related to the following products: