Stationary operation – Lenze 8615E User Manual
Page 79
Advertising
M
Torque characteristic of the motor
Stationary
Operation
= act. value
Output frequency
Pilot control of
Closed-loop control without
control, closed-loop control
of an application datum
The Pl
is normally used for the
control of the
connected motor. The large setting
of the control
Parameters also
the control of an application datum if this
depends on the drive
For this it may be
to
off the frequency
control and to set the Pl Controller to 100%
influence.
The act. value gain and the control Parameters must be adjusted
according to the corresponding conditions.
With
value
77
Advertising
This manual is related to the following products: